No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX116 Pass-Through Module V100R001 User Guide 16

This document describes the CX116 gigabit Ethernet (GE) pass through module of the Tecal E9000 server (short for E9000) in terms of its features, installation, removal, and maintenance.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Changing the Password of the BMC

Changing the Password of the BMC

Scenarios

This task provides guidance for software commissioning engineers to change the initial password of the BMC to enhance security of the system after the first login to the CX116.

NOTE:
  • The password complexity check is enabled by default.
  • Use passwords that meet complexity requirements.
  • For security purposes, change the initial password upon the first login, and then change the password periodically.

Procedure

  1. Use the PuTTY to log in to the active MM910.

    For details, seeLogging In to a Server Over a Network Port by Using PuTTY .

  2. Change the password of the BMC by running the following command:

    smmset -l swiN -d bmcuserpasswd -v username

    N indicates the slot number of a CX116, in the range of 1 to 4.

    username indicates the user name of the CX116.

    For example, if the slot number of a CX116 is 4 and the user name is root, run the following command:

    smmset -l swi4 -d bmcuserpasswd -v root

    The command output is as follows:

    The currently logged user's passwd:     

  3. Enter the password of username root and press Enter.

    The command output is as follows:

    New password:     

  4. Enter a new password and press Enter.

    NOTE:

    A password contains any three types of uppercases, lowercases, digits, and special characters.

    The command output is as follows:

    Retype new password:     

  5. Enter the new password again and press Enter.

    The command output is as follows:

    Success     

Translation
Download
Updated: 2018-09-20

Document ID: EDOC1000015889

Views: 12352

Downloads: 487

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next