No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX910 Switch Module V100R001C00 User Guide 22

This document describes the CX910 10GE switch module (CX910 for short) of the Tecal E9000 server in terms of its features, installation, removal, and configuration. This document applies to the CX910 whose GE/10GE switching planes use the software versions of 1.1.x.x.x, and 1.23-1.99.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Ports

Ports

This topic describes the features, number rules, names, types, and quantity of the CX910 ports.

Overview

The CX910 provides ports for users to operate and configure. The ports are used to send and receive data.

Table 2-2 describes the ports on the CX910.

Table 2-2 Ports

Port

Type

Quantity

Description

Serial port

RJ–45

2

The serial ports include the baseboard management controller (BMC) serial port and the SYS serial port. The ports comply with RS232, and the port type is RJ45. No indicator is available.

  • BMC serial port: The port is used to log in to the BMC command-line interface (CLI).
  • SYS serial port: This port is used for managing, maintaining, and commissioning the 10GE switching plane.

The BMC serial port and serial ports of the 10GE switching plane support the baud rate of 115,200 bit/s.

GE electrical port

RJ–45

4

This port is used to control and manage the server.

Each port has two indicators. The orange one is a data transmission status indicator, and the green one is a connection status indicator.

10GE optical port

SFP+

16

This port is used to exchange data with a service network.

Each port has two indicators. The orange one is a data transmission status indicator, and the green one is a connection status indicator.

Port number rules

The CX910 Ethernet ports are numbered in Slot number/Subcard number/Port number format on the CLI.

  • Slot number: Its value is 0.
  • Subcard number: Its value is 0.
  • Port number: indicates the sequence number of an Ethernet port on the panel. The ethernet electrical port value ranges from 1 to 4, the ethernet optical port value ranges from 1 to 16, as shown in Figure 2-5.

Figure 2-5 shows the Ethernet electrical port numbers. The number of the first port in the upper right area is Gigabit Ethernet 0/0/4.

Figure 2-5 Port naming rules
Translation
Download
Updated: 2018-09-20

Document ID: EDOC1000015891

Views: 15760

Downloads: 342

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next