No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX913 Switch Module V100R001C00 User Guide 22

This document describes the CX913 10GE switch module (CX913 for short) of the Tecal E9000 server in terms of its features, installation, removal, and configuration. This document applies to the CX913 whose GE/10GE switching planes use the software versions of 1.1.x.x.x, and 1.23-1.99.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Overview

Overview

Configuration Process

Figure 4-1 Switch module configuration process
Table 4-1 Configuration procedure

Configuration Procedure

Description

Configure the password for login over a serial port.

You need to set the login password when logging in to the 10GE switching plane of the CX913 over a serial port for the first time. This password is used only for login over a serial port.

Configure the IP addresses of management network ports.

Configure the IP addresses of the management network ports for the 10GE switching plane of the CX913.

Log in to the command-line interface (CLI) of each switching plane.

Log in to the CLI of each switching plane for the CX913 over Secure Shell (SSH), serial over LAN (SOL), or a serial port. You can select a login method as required.

Check the switching plane.

  • Check whether the versions of the 10GE switching plane of the CX913 are the required ones.
  • Check the mappings between the 10GE switching plane of the CX913 and compute nodes, storage nodes, and management modules.

Change initial user passwords.

Change the initial user passwords after the first login to the CX913 to ensure the security of system operating and maintenance.

This topic describes how to change the initial user passwords of the BMC, 10GE switching plane, and Bootrom.

Add users.

Add users to the 10GE switching plane of the CX913. Then the new users can log in to the command-line interface (CLI) of the corresponding switch plane to carry out routine maintenance.

Configure switching service data.

Describe the switching service data supported by the 10GE switching plane in the CX913.

Back up configuration files.

Back up the configuration files of the 10GE switching plane of the CX913. If configuration errors occur or the CX913 is damaged, you can use the backup configuration files to restore configuration data.

Reference Manuals

The manuals about the 10GE switching plane in the CX913 are as follows:

Translation
Download
Updated: 2018-09-20

Document ID: EDOC1000015895

Views: 13464

Downloads: 191

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next