No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX913 Switch Module V100R001C00 User Guide 22

This document describes the CX913 10GE switch module (CX913 for short) of the Tecal E9000 server in terms of its features, installation, removal, and configuration. This document applies to the CX913 whose GE/10GE switching planes use the software versions of 1.1.x.x.x, and 1.23-1.99.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Switching Service Data

Configuring Switching Service Data

Scenarios

For details about how to configure the 10GE switching plane feature data of the CX913, see description in this topic.

Procedure

  1. Configure the features of the 10GE switching plane in the CX913.

    The following describes the feature configurations of the 10GE switching plane. For details, see CX91x Series Switch Modules V100R001C00 Configuration Guide.

    • Ethernet
      • Ethernet Interface Configuration
      • Link Aggregation Configuration
      • VLAN Configuration
      • MAC Address Table Configuration
      • ARP Configuration
      • MSTP Configuration
    • IP Services

      IP Address Configuration

    • QoS
      • Class-based QoS Configuration
      • Traffic Policing and Traffic Shaping Configuration
      • Congestion Management Configuration
    • Security
      • Traffic Suppression Configuration
      • ACL Configuration
    • Reliability

      Smart Link and Monitor Link Configuration

    • Device Management
      • Using display commands to check the status of the device
      • Monitoring the Device Through the Information Center
      • Mirroring
      • Restarting
    • Network Management
      • SNMP Configuration
      • Ping and Tracert

Translation
Download
Updated: 2018-09-20

Document ID: EDOC1000015895

Views: 12381

Downloads: 190

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next