No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

E9000 Server V100R001 User Guide 24

This document describes the overview, functions, structure, installation, and configuration methods of the E9000.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Attaching Labels

Attaching Labels

Attaching Labels to the PGND and Power Cables

Attach a PGND cable label or power cable label to the ID plate on the cable tie. Tighten the cable tie with the label to the cable and ensure that the label is 20 mm (0.79 in.) away from the connector, as shown in Figure A-4.

NOTE:
  • The labels must be attached to the same side of the ID plates.
  • The distance between the label and the connector can be adjusted as required. Ensure that the distance is the same for all cables.
  • Ensure that the ID plate with the label is on the right side of the cable in vertical cabling, or on top of the cable in horizontal cabling. Ensure that the label is facing outwards.
Figure A-4 Attaching labels to the PGND and power cables

Attaching a Label to the Power Cable of Internal Components

Attach a label to a power cable and ensure that the label is 20 mm (0.79 in.) away from the connector, as shown in Figure A-5.

NOTE:
  • The distance between the label and the connector can be adjusted as required. Ensure that the distance is the same for all cables.
  • Ensure that the ID plate with the label is on the right side of the cable in vertical cabling, or on top of the cable in horizontal cabling. Ensure that the label is facing outwards.
Figure A-5 Attaching a label to the power cable of internal components

Attaching a Signal Cable Label

Attach a label to a signal cable and ensure that the label is 20 mm (0.79 in.) away from the connector. Then fold the label. See Figure A-6 and Figure A-7.

NOTE:
  • The distance between the label and the connector can be adjusted as required. Ensure that the distance is the same for all cables.
  • Ensure that the ID plate with the label is on the right side of the cable in vertical cabling, or on top of the cable in horizontal cabling. Ensure that the label is facing outwards.
Figure A-6 Attaching a signal cable label (1)
Figure A-7 Attaching a signal cable label (2)
Translation
Download
Updated: 2019-08-30

Document ID: EDOC1000015897

Views: 95690

Downloads: 5268

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next