No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

E9000 Server V100R001 User Guide 24

This document describes the overview, functions, structure, installation, and configuration methods of the E9000.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Physical Structure

Physical Structure

This section describes the physical structure and components of the E9000.

Hardware Structure

Figure 2-5 Hardware structure
Table 2-2 E9000 chassis components

No.

Component

Description

1

Chassis

This is a 12U chassis, providing 8 full-width or 16 half-width compute node slots at the front, and 2 management module slots, 6 PSU slots, 14 fan module slots, and 4 switch or pass-through module slots at the rear.

2

Compute nodes

A variety of half-width and full-width compute nodes are supported and can be flexibly selected based on service needs.

3

Fan modules

Fourteen hot-swappable fan modules can be configured and divided into three zones.

4

Pass-through or switch modules

Four pass-through or switch modules can be configured to provide external ports.

5

Management modules

Two management modules can be configured to manage all hardware devices in the chassis, with support for active/standby switchovers and hot-swap.

6

PSUs

Six hot-swappable PSUs work in N+1 or N+N redundancy mode.

Front Panel

Figure 2-6 Front panel

1

Half-width compute nodes

2

Full-width compute nodes

3

Chassis intelligent display

4

ESN label

NOTE:

The front slots of the E9000 are divided into four zones. Only zone 4 supports mixed installation of half-width and full-width compute nodes.

Rear Panel

Figure 2-7 Rear panel

1E, 2X, 3X, and 4E

Slots for installing switch modules and pass-through modules. It is recommended that pass-through modules be installed in slots 1E and 4E to facilitate cable routing.

MM1 and MM2

Slots for installing management modules.

PSU 1 to PSU 6

Slots for installing PSUs.

(1) to (14)

Slots for installing fan modules.

ESD jack

A jack for inserting the ESD wrist strap.

PGND

Ground terminal.

Translation
Download
Updated: 2019-08-30

Document ID: EDOC1000015897

Views: 95206

Downloads: 5262

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next