No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

E9000 Server V100R001 User Guide 24

This document describes the overview, functions, structure, installation, and configuration methods of the E9000.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Replacing a Fan Module

Replacing a Fan Module

After removing a fan module, install a new one.

  • The server supports a maximum of fourteen fan modules, The replacement method is the same. The following describes how to replace one fan module.
  • Only one fan module can be replaced at a time. After replacing a fan module, check the indicators on the newly installed fan module. Proceed with the next fan module only after ensuring that the newly installed one is in health status.

Workflow

Figure 6-55 Process

Procedure

  1. Determine the fan module to be replaced.

    Figure 6-56 shows the slot numbers of the fan modules.
    Figure 6-56 Slot numbers of the fan modules

  2. Remove the fan module.

    1. Hold down the latch on the inner side of the handle. See (1) in Figure 6-57.
      Figure 6-57 Removing a fan module
    2. Horizontally pull out the fan module from the chassis. See (2) in Figure 6-57.

      Each ESD bag should hold only one fan module.

    3. Place the removed fan module into an ESD bag.

  3. Install a new fan module.

    1. Align the fan module with the slot, and make sure that the indicators on the module are on the same side as those shown in the identifier on the air baffle.
      Figure 6-58 Identifier on the air baffle
    2. Horizontally insert the fan module into the chassis until the fan module snaps into the chassis, as shown in Figure 6-59.
      Figure 6-59 Installing a fan module

  4. Check the indicator status.

    For details, see Fan Modules.

Translation
Download
Updated: 2019-08-30

Document ID: EDOC1000015897

Views: 96513

Downloads: 5270

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next