No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

MM910 Management Module V100R001 User Guide 24

This document provides the product description, installation and configuration methods, and common operations of the E9000 server chassis management module MM910.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Time Zone and NTP

(Optional) Configuring the Time Zone and NTP

Scenarios

Configure the time zone and NTP time synchronization for the MM910.

You can configure the time zone and NTP time synchronization using the MM910 WebUI or CLI. The following describes how to use the MM910 WebUI to configure the time zone and NTP time synchronization for the MM910. For details about the configuration based on the MM910 CLI, see MM910 Management Module V100R001 Command Reference.

Prerequisites

Conditions

None.

Data

Table 4-9 describes the data that you need to obtain before performing this task.

Table 4-9 Required data

Parameter

Description

Example Value

NTP server IP addresses

IP address of the system clock source server.

NOTE:

The MM910 only supports Linux NTP servers.

  • Preferred NTP server IP address: 192.168.130.1
  • Alternative NTP server IP address: 192.168.130.2

Procedure

  1. Log in to the WebUI of the active MM910.

    For details, see Logging In to the MM910 WebUI.

  2. Choose System Management > System Settings > Timezone & NTP, as shown in Figure 4-15.
    Figure 4-15 Timezone & NTP

  3. Click Edit.
  4. Set the parameters.
    Table 4-10 Parameter description

    Parameter

    Description

    Time zone

    Time zone for the system.

    NOTE:

    If the system supports daylights saving time (DTS), the system time will be automatically adjusted based on the DTS.

    Time

    System time.

    You can manually set the time or select Sync to synchronize the system time with the PC used for accessing the MM910 WebUI.

    NOTE:

    After setting the time, click Save. You may need to re-login.

    NTP

    Function of enabling NTP.

    • On: enables NTP.
    • Off: disables NTP.

    NTP synchronization

    Status of time synchronization between the system and the NTP server.

    Preferred NTP Server

    IP address of the preferred NTP server. The system synchronizes the time with the preferred NTP server.

    NOTE:

    The MM910 only supports Linux NTP servers.

    Alternate NTP Server

    IP address of an alternative NTP.

    NOTE:

    The MM910 only supports Linux NTP servers.

    Min poll interval (hh:mm:ss)

    Minimum interval (in seconds) for synchronizing NTP packets.

    Value: 2n (4 ≤ n ≤ 17)

    Max poll interval (hh:mm:ss)

    Maximum interval (in seconds) for synchronizing NTP packets.

    Value: 2n (4 ≤ n ≤ 17)

  5. Click Save.
Translation
Download
Updated: 2019-04-10

Document ID: EDOC1000015900

Views: 70970

Downloads: 5175

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next