No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

MM910 Management Module V100R001 User Guide 24

This document provides the product description, installation and configuration methods, and common operations of the E9000 server chassis management module MM910.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the MM910

Checking the MM910

Scenarios

After the MM910 is powered on, check its health status and software version on the HMM WebUI or CLI.

The following describes how to check the MM910 health status and software version on the HMM WebUI. For details about how to use the CLI, see MM910 Management Module V100R001 Command Reference.

Prerequisites

Conditions

The MM910 is powered on.

Data

Data preparation is not required for this operation.

Procedure

  1. Check the software version.

    1. Log in to the WebUI of the active MM910. For details, see Logging In to the MM910 WebUI.
    2. On the HMM Web, click the management module in Rear view, and select the Version Information tab.

      The Version Information tab is displayed, as shown in Figure 4-8.

      Figure 4-8 Version Information page

      Software Version indicates the MM910 software version.

    3. Check that the MM910 software version is correct.

      If the MM910 software version is not correct, upgrade the software. For details, see E9000 Server V100R001 Upgrade Guide.

  2. Check the health status.

    1. Check the indicator status on the MM910s.

      The MM910s are working properly if the status of the indicators on the active and standby MM910s are as follows:

      • Active MM910: The PWR, HLY, and ACT indicators are steady green.
      • Standby MM910: The PWR and HLY indicators are steady green, and the ACT indicator is off.

        For details about the indicators, see Indicators.

    2. On the HMM Web, select the Alarms tab, as shown in Figure 4-9.
      Figure 4-9 Alarms page
    3. Check for active alarms.

      For details about how to handle alarms, see E9000 Server V100R001 Alarm Handling.

Translation
Download
Updated: 2019-04-10

Document ID: EDOC1000015900

Views: 81019

Downloads: 5205

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next