No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

MM910 Management Module V100R001 User Guide 24

This document provides the product description, installation and configuration methods, and common operations of the E9000 server chassis management module MM910.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Component Alarm Monitoring

Component Alarm Monitoring

GUI

Function

On the Alarm Monitoring page, you can view the status of indicators and sensors of components in a chassis. For details, see Table 7-79.

Table 7-79 Status of indicators and sensors

Category

Name

Description

Indicators

HLY

Health status indicator. The indicator status is as follows:

  • Off: indicates that the device is not powered on.
  • Green: indicates that the device hardware is operating properly.
  • Red: indicates that an alarm is generated by the device.

UID

The Unit Identification (UID) indicator helps locate a compute node in a rack. You can control the UID indicator status (off or on) by remotely using the MM910 or by manually pressing the UID indicator.

  • Off: The compute node is not located or is not powered on.
  • On: The compute node is located.
NOTE:

If a compute node is powered on, you can hold down the button for 6 seconds to reset BMC.

PWR

Power button and indicator. The indicator status is as follows:

  • Off: indicates that the device is not powered on.
  • Green: indicates that the device is successfully powered on.

ACT

Active/standby status indicator for the MM910. The indicator status is as follows:

  • Off: indicates that the MM910 is in standby state.
  • Steady green: indicates that the MM910 is in active state.

Sensors

Threshold Sensors

A type of sensor with alarm thresholds. The sensor status change is continuous. The alarm thresholds of each threshold sensor are displayed on the MM910 web user interface (WebUI).

Discrete Sensors

A type of sensor with fixed parameter values. The sensor status change is discrete. The status of each discrete sensor is displayed on the MM910 WebUI.

Set Alarm Severity

Management port

  • Set the severity of the Alarm Caused by Network Failure of Management Network Ports alarm. The default value is Critical.
  • Only administrators and operators of the super domain can set this parameter.

Setting the Thresholds and Hysteresis of a Threshold Sensor

NOTE:

Log in to the WebUIs of the active and standby MM910s respectively to query or set the thresholds and hysteresis of threshold sensors.

  1. On the Threshold Sensors tab page, click the name of the target sensor in the Sensor column. See Figure 7-28.

    The sensor setting page is displayed.

    Figure 7-28 Threshold sensor

  2. On the page shown in Figure 7-29, set the alarm thresholds, positive hysteresis, and negative hysteresis for the sensor.

    When setting the parameters, follow these rules:

    • You can set alarm thresholds only in the text boxes without N/A.
    • If all alarm thresholds are N/A, no hysteresis can be set.
    • Alarm thresholds are associated with a positive hysteresis and negative hysteresis. You are advised to set the thresholds and hysteresis one by one.
    Figure 7-29 Sensor setting page

  3. Click OK.
Translation
Download
Updated: 2019-04-10

Document ID: EDOC1000015900

Views: 70378

Downloads: 5173

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next