Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the NQA Client to Send Traps When a Test Fails
Procedure
- Run:
system-viewThe system view is displayed.
- Run:
nqa test-instance admin-name test-name
The NQA view is displayed.
- Run:
send-trap testfailure
The NQA client is configured to send traps when the test fails.
By default, the NQA client sends no trap when an NQA test fails.
- Run:
test-failtimes times
The threshold on the traps sent after the NQA test fails is configured, The threshold specifies maximum number of continuous test failures for the NQA test instance.
By default, a trap is sent for each test failure.
