No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CH222 Compute Node V100R001 User Guide 18

This document describes the appearance, functions, structure, and installation, removal, and configuration methods of the CH222 compute node.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing the CH222

Removing the CH222

This topic describes the precautions and procedures for removing the CH222 from the E9000 chassis.

Scenarios

Remove the CH222 from the HUAWEI E9000 chassis. Before the operation, you must get familiar with the hardware devices.

Impact on the System

After the CH222 is removed, all services running on the CH222 stop.

Prerequisites

Conditions

  • Refer to Safety Instructions.
  • Gracefully power off the CH222 by shutting down the operating system (OS).

Data

Data preparation is not required for this operation.

Tools

The following tools are available:

  • Protective gloves.
  • Electrostatic discharge (ESD) gloves.
  • ESD bag.

Workflow

Figure 3-10 shows the procedure for removing the CH222.

Figure 3-10 Procedure for removing the compute node

Procedure

  1. Determine the compute node to be removed.

    Determine the CH222 to be removed. For details about the slot numbers for the CH222s, see Figure 3-11.
    Figure 3-11 Slot numbers

  2. (Optional) Remove the high-density cable.

    1. Press the two tabs on the high-density cable connector. See step (1) in Figure 3-12.
      Figure 3-12 Removing the high-density cable
    2. Remove the high-density cable from the high-density port on the CH222. See step (2) in Figure 3-12.

  3. Remove the compute node.

    1. Press the springs on the CH222. See step (1) in Figure 3-13.
      Figure 3-13 Removing the CH222
    2. Raise the ejector levers on the CH222 completely. See step (2) in Figure 3-13.
    3. Pull out the CH222 horizontally from the chassis. See step (3) in Figure 3-13.
    4. Lower the two ejector levers on the CH222. See step (4) in Figure 3-13.
    5. An ESD bag can hold only one CH222.

      Place the removed CH222 in an ESD bag.

  4. Install the filler panel.

    1. Press the spring on the filler panel. See step (1) in Figure 3-14.
      Figure 3-14 Installing the filler panel
    2. Raise the ejector lever on the filler panel completely. See step (2) in Figure 3-14.
    3. Insert the filler panel into the chassis. See step (3) in Figure 3-14.
    4. Lower the ejector lever on the filler panel. See step (4) in Figure 3-14.
    NOTE:

    Install a filler panel in a vacant slot. Otherwise, the ventilation, heat dissipation, electromagnetic shielding, and dust resistance effect of the chassis will be affected.

Translation
Download
Updated: 2019-08-16

Document ID: EDOC1000018075

Views: 6572

Downloads: 321

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next