No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CH222 Compute Node V100R001 User Guide 18

This document describes the appearance, functions, structure, and installation, removal, and configuration methods of the CH222 compute node.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing a BIOS Battery

Removing a BIOS Battery

If a BIOS battery is faulty or is low in power, remove it before replacing it with a new one.

Scenarios

Remove a BIOS battery in either of the following scenarios:

  • A BIOS battery is faulty.
  • A BIOS battery is low in power.

Figure 5-48 shows the position of the BIOS battery in the CH222.

Figure 5-48 Position of the BIOS battery

Prerequisites

Conditions

Data

Data preparation is not required for this operation.

Tools

  • Electrostatic discharge (ESD) gloves
  • Packing materials, for example, ESD bag
  • M3 phillips screwdriver.

Procedure

  1. Press and hold down the spring on a RAID controller card connector and remove the MiniSAS cable from the RAID controller card. See steps (1) and (2) in Figure 5-49.

    Figure 5-49 Removing a Mini-SAS cable

  2. Remove the bridge board between the hard disk drawer and the expansion board, as shown in Figure 5-50.

    Figure 5-50 Removing the bridge board

  3. Only personnel authorized by Huawei and Huawei technical support personnel can remove the mainboard.

    Use the Phillips screw to remove the three captive screw on the CH222 mainboard. See step (1) in Figure 5-51.

    Figure 5-51 Removing the mainboard

  4. Pull one fourth of the CH222 mainboard out of the backend until the BIOS battery is exposed. See step (2) in Figure 5-51.
  5. Take out the BIOS battery in the arrow direction.

    Figure 5-52 Removing a BIOS battery

  6. Place the removed BIOS battery in an ESD bag.
Translation
Download
Updated: 2019-08-16

Document ID: EDOC1000018075

Views: 6565

Downloads: 321

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next