No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CH222 Compute Node V100R001 User Guide 18

This document describes the appearance, functions, structure, and installation, removal, and configuration methods of the CH222 compute node.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the iMana 200 IP Address

Configuring the iMana 200 IP Address

This topic describes how to configure integrated management module (iMana 200) IP address of the CH222.

Scenarios

Log in to the CH222 over a serial port and configure the CH222 iMana 200 IP address.

Prerequisites

Conditions

The compute node iMana 200 IP address cannot be on the network segment for the chassis management plane.

NOTE:

The network segment for the chassis management plane is used for functions such as HMM and iMana 200 heartbeats.

Data

The CH222 iMana 200 IP address and subnet mask must be available.

Procedure

  1. Configure the iMana 200 IP address of the compute node.

    To avoid conflicts with the network segment for the chassis management plane (172.31), the compute node iMana 200 IP address cannot be on the 172.31 network segment. If you need to set it to be on the 172.31 network segment, change the network segment for the chassis management plane first. For details, see section "Querying and Setting a Network Segment for the Management Plane of a Chassis (subnet)" in the MM910 Management Module V100R001 Command Reference.

    Run the following command:

    ipmcset -t network port number -d ipaddr -v iMana IP address subnet mask

    The network port number of iMana 200 is eth0, if iMana 200 IP address is 192.168.100.194, and the subnet mask is 255.255.255.0, run the following command:

    ipmcset -t eth0 -d ipaddr -v 192.168.100.194 255.255.255.0

    The iMana 200 IP address is successfully configured if the following information is displayed:

    Set IP address 192.168.100.194 successfully . 
    Set MASK address 255.255.255.0 successfully .

  2. Run the following command to view the configured iMana 200 IP address:

    ipmcget -t eth0 -d ipinfo

    The following information is displayed:

    Enabled : Enable 
    Mode : static 
    Inet addr : 192.168.100.194 
    Subnet Mask : 255.255.255.0 
    Default Gateway : 
    HWaddr : 00:18:82:59:23:03     

Translation
Download
Updated: 2019-08-16

Document ID: EDOC1000018075

Views: 6617

Downloads: 321

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next