No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CH222 Compute Node V100R001 User Guide 18

This document describes the appearance, functions, structure, and installation, removal, and configuration methods of the CH222 compute node.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to the MM910 CLI Over a Network Port by Using PuTTY

Logging In to the MM910 CLI Over a Network Port by Using PuTTY


Use PuTTY to log in to the MM910 command line interface (CLI) through a network port.


The compute nodes and switch modules of the E9000 do not provide the MGMT management port. To log in to a compute node or switch module, see Logging In to a Compute Node or a Switch Module over MM910 SOL.





  • IP address of the MM910 to be connected.
  • User name and password for logging in to the MM910.


PuTTY.exe: third-party software used for remote access on various platforms.


  1. Connect the local PC and the MGMT port on the MM910 through a network cable.
  2. Set an IP address and a subnet mask or add route information for the PC to enable communication between the PC and the MM910.

    To check the connectivity between the PC and the device, run the Ping MM910 IP address command on the PC CLI.

  3. Double-click PuTTY.exe.

    The PuTTY Configuration window is displayed.

  4. In the navigation tree on the left, choose Connection > SSH.
  5. Set the login parameters as follows:

    • Host Name (or IP address): Enter the IP address of the MM910 to be logged in to, for example,
    • Port: Use the default value 22.
    • Connection type: Use the default value SSH.
    • Close window on exit: Use the default value Only on clean exit.

    Set Host Name and Saved Sessions, and click Save. You can double-click the saved record in Saved Sessions to log in to the MM910 the next time.

  6. In the navigation tree, choose Session, and select SSH for Connection type, as shown in Figure 6-1.

    Figure 6-1 PuTTY Configuration

  7. (Optional) Choose Terminal > Keyboard, and select Control-H under The Backspace key, as shown in Figure 6-2.

    This setting can solve the problem that the characters on the CLI cannot be deleted by using the Backspace key.

    Figure 6-2 PuTTY Configuration

  8. Click Open.


    If this is your first login to the server, the PuTTY Security Alert dialog box is displayed. Click Yes to proceed.

    The following information is displayed:

    login as:

  9. Enter the user name and password.


    If an incorrect user name or password is entered, you must set up a new PuTTY session.

    If the login is successful, the server host name is displayed on the left of the prompt.

Updated: 2019-08-16

Document ID: EDOC1000018075

Views: 8267

Downloads: 321

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next