Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Switching Plane
Procedure
- Log in to the converged switching plane CLI.
- Run the following command on the converged switching plane CLI to check the current version of the converged switching plane:
<HUAWEI> display version
The command output is as follows:
Huawei Versatile Routing Platform Software VRP (R) software, Version 8.50 (OSCA V100R001C03) Copyright (C) 2012-2013 Huawei Technologies Co., Ltd. HUAWEI OSCA uptime is 0 day, 0 hours, 1 minutes CX310(Master) 1 : uptime is 0 day, 0 hours, 1 minutes StartupTime 2013/05/16 17:43:57 Memory Size : 2048 M bytes FLASH Size : 1024 M bytes CX310 version information 1. PCB Version : CX310 VER B 2. MAB Version : 0 3. Board Type : CX310 4. CPLD1 Version : 001 5. BIOS Version : 2.42 6. Software Version : 1.01Software Version indicates the current software version.
- Check whether the software version is consistent with the planned one.
- If yes, go to 4.
- If no, contact Huawei technical support.
- Query the alarms of the converged switching plane.
<HUAWEI> display alarm active
The command output is as follows:
1:Critical 2:Major 3: Minor 4:Warning ------------------------------------------------------------------ Sequence AlarmId Level Date Time Description ------------------------------------------------------------------
The parameters are described as follows:
- Critical: critical alarm
- Major: major alarm
- Minor: minor alarm
- Warning: warning alarm
- Sequence: alarm sequence
- AlarmId: alarm ID
- Level: alarm severity
- Date Time: date and time at which an alarm is generated
- Description: alarm description
If no information is displayed, no alarm is generated.
- Check whether an alarm is generated.
- If yes, go to 6.
- If no, no further action is required.
- Handle the alarm. For details, see the E9000 Server V100R001 Alarm Handling.
