No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CX311 Switch Module V100R001C00 User Guide 22

This document describes the CX311 10GE / FCoE converged switch module of the Tecal E9000 server in terms of its features, installation, removal, and configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Switching Service Data

Configuring Switching Service Data


Configure the features of the CX311 converged switching plane.

The following lists the feature configurations of the converged switching plane. For details, see the CX110 and CX31x Series Switch Modules V100R001C00 Configuration Guide.
  • Interface Management
    • Basic Configuration for Interfaces
    • Ethernet Interfaces Configuration
    • Logical Interface Configuration
  • Ethernet Switching
    • MAC Address Table Configuration
    • Link Aggregation Configuration
    • VLAN Configuration
    • QinQ Configuration
    • VLAN Mapping Configuration
    • STP/RSTP Configuration
    • MSTP Configuration
    • Loopback Detection Configuration
  • IP Service
    • IP Address Configuration
    • ARP Configuration
    • DHCP Configuration
    • DNS Configuration
    • UDP Helper Configuration
    • IP Performance Configuration
  • IP Routing
    • IP Routing Basic Configuration
    • Static Route Configuration
    • RIP Configuration
    • OSPF Configuration
    • OSPFv3 Configuration
    • IPv4 IS-IS Configuration
    • BGP Configuration
    • Routing Policy Configuration
    • MCE Configuration
  • IP Multicast
    • IGMP Configuration
    • PIM (IPv4) Configuration
    • MSDP Configuration
    • Multicast Route Management (IPv4) Configuration
    • IGMP Snooping Configuration
    • Static Multicast MAC Address Configuration
    • Multicast Network Management
  • QoS
    • Priority Mapping Configuration
    • Traffic Policing and Traffic Shaping Configurations
    • Congestion Avoidance and Congestion Management Configuration
    • Traffic Policy Configuration
  • Security
    • AAA Configuration
    • ACL Configuration
    • Local Attack Defense Configuration
    • MFF Configuration
    • Traffic Suppression and Storm Control Configuration
    • ARP Security Configuration
    • DHCP Snooping Configuration
    • IPSG Configuration
    • URPF Configuration
    • Keychain Configuration
  • Reliability
    • BFD Configuration
    • VRRP Configuration
    • DLDP Configuration
  • Device Management
    • Displaying the Device Status
    • Hardware Management
    • Information Center Configuration
    • Fault Management Configuration
    • Energy-Saving Management
    • Mirroring Configuration
    • iStack Configuration
  • Network Management
    • SNMP Configuration
    • RMON Configuration
    • NETCONF Configuration
    • LLDP Configuration
    • NTP Configuration
    • Ping and Tracert Configuration
    • NQA Configuration
    • Packet Capture Configuration
  • FCoE&DCB
    • FCoE Configuration
    • DCB Configuration
    • Configuring the CX311 to Connect to the FCoE Gateway
  • Virtual Perception
Updated: 2018-09-20

Document ID: EDOC1000018097

Views: 60524

Downloads: 3389

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next