No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX311 Switch Module V100R001C00 User Guide 22

This document describes the CX311 10GE / FCoE converged switch module of the Tecal E9000 server in terms of its features, installation, removal, and configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the IP Address of the Management Network Port

Configuring the IP Address of the Management Network Port

  • Configure the IP address of the FCoE gateway on the FCoE gateway CLI. For details, see Procedure.
  • Configure the IP address of the management network port for the FCoE gateway by running the swipcontrol command on the MM910 CLI. For details, see the MM910 Management Module Command Reference.

Prerequisites

Data

Table 4-9 Required data

Name

Description

Value Example

IP address, subnet mask, and gateway of the FCoE gateway

You can log in to the FCoE gateway CLI from a PC by using the IP address.

  • IP address: 192.168.101.123
  • Subnet mask: 255.255.255.0
  • Gateway: 192.168.101.1

Software

PuTTY.exe: free software. The PuTTY used to log in over a serial port must be 0.60 or later.

Procedure

  1. Log in to the FCoE gateway CLI.

    For details, see Logging In to the CLI of Each Switching Plane.

  2. Set the IP address of the management network port for the FCoE gateway.

    FCoE_GW: admin> admin start

    FCoE_GW (admin): admin> set setup system ipv4

    Set the static IPv4 address of the FCoE gateway based on command instructions.

    EthIPv4NetworkDiscovery (1=Static, 2=Bootp, 3=Dhcp, 4=Rarp) :1 
    EthIPv4NetworkAddress (dot-notated IP Address) : 192.168.101.123 
    EthIPv4NetworkMask (dot-notated IP Address) : 255.255.255.0 
    EthIPv4GatewayAddress (dot-notated IPv4 Address) : 192.168.101.254 
    Do you want to save and activate this system setup? (y/n): [n] y

  3. Query the static IPv4 address of the FCoE gateway.

    FCoE_GW (admin): admin> show setup system ipv4

    The command output is as follows:

    System Information 
      ------------------ 
      Eth1IPv4NetworkDiscovery  Static 
      Eth1IPv4NetworkAddress    192.168.101.123 
      Eth1IPv4NetworkMask       255.255.255.0 
      Eth1IPv4GatewayAddress    192.168.101.254     

Translation
Download
Updated: 2018-09-20

Document ID: EDOC1000018097

Views: 62646

Downloads: 3389

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next