No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX311 Switch Module V100R001C00 User Guide 22

This document describes the CX311 10GE / FCoE converged switch module of the Tecal E9000 server in terms of its features, installation, removal, and configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the FCoE Gateway

Checking the FCoE Gateway

Procedure

  1. Log in to the FCoE gateway CLI.
  2. Run the following command on the FCoE gateway CLI to check the current version of the FCoE gateway:

    FCoE_GW: admin> show version

    The command output is as follows:

           ***************************************************** 
           *                                                   * 
           *       Command Line Interface SHell  (CLISH)       * 
           *                                                   * 
           ***************************************************** 
     
           SystemDescription Huawei FCoE-FC Gateway module 
           HostName            <undefined> 
           Eth1IPv4NetworkAddr 192.168.96.96 
           Eth1IPv6NetworkAddr fe80::2c0:ddff:fe24:21fe 
           MAC1Address         00:c0:dd:24:21:fe 
           WorldWideName       10:00:00:c0:dd:24:21:fd 
           SerialNumber        2198080446DQCB46F882 
           SymbolicName        FCoE_GW 
           ActiveSWVersion     V9.8.0.10.0 
           ActiveTimestamp     Fri May 17 21:19:51 2013 
           POSTStatus          Passed 
           SwitchMode          Full Fabric
    • Eth1IPv4NetworkAddr: specifies the IP address of the management network port.
    • ActiveSWVersion: specifies the software version.
    • SwitchMode: specifies the work mode.

  3. Check whether the software version is consistent with the planned one.

    • If yes, go to 4.
    • If no, contact Huawei technical support.

  4. Query the alarms of the FCoE gateway.

    FCoE_GW: admin> show alarm

    If the following information is displayed, no alarm is generated.

     Current Faults:  None     

  5. Check whether an alarm is generated.

    • If yes, go to 6.
    • If no, no further action is required.

  6. Handle the alarm. For details, see the MX510 Mezzanine Module QuickTool User Guide.
Translation
Download
Updated: 2018-09-20

Document ID: EDOC1000018097

Views: 60615

Downloads: 3389

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next