No relevant resource is found in the selected language.
Your browser version is too early. Some functions of the website may be unavailable. To obtain better user experience, upgrade the browser to the latest version.
CloudEngine 8800, 7800, 6800, and 5800 Series Switches Hardware Description (Versions earlier than V200R020C00)
This document provides an overall description of the CE5800&6800&7800&8800 series switches hardware that versions earlier than V200R020C00, helping you obtain detailed information about each chassis, power module, fan module, card, cable, and pluggable modules for ports.
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
380 V High-Voltage DC Power Cable
380 V High-Voltage DC Power Cable
Appearance and Structure
Figure 6-9 shows the appearance of a 380 V high-voltage DC power cable.
Figure 6-9 380 V high-voltage DC power cable (high-voltage DC straight female connector to bare wires)
Connection
A 380 V high-voltage DC power cable has a high-voltage DC straight female connector at one end and bare wires at the other end, and is used to connect a 600 W high-voltage DC power module or 1200 W high-voltage DC power module to a power supply device:
The high-voltage DC straight female connector is connected to the power socket of the 600 W high-voltage DC power module or 1200 W high-voltage DC power module.
The bare wires are connected to a 380 V high-voltage DC power distribution frame or power distribution box. Crimp OT or cord end terminals on the bare wires, and then connect the blue wire to a negative terminal, the brown wire to a positive terminal, and the yellow-green wire to a protection ground. If the switch fails to be powered on after you connect the power cable, swap the wires on the positive and negative terminals.