No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX910 Switch Module V100R001C10 User Guide 15

This document describes the CX910 10GE switch module (CX910 for short) of the Tecal E9000 server in terms of its features, installation, removal, and configuration. This document applies to the CX910 whose 10GE switching planes use the software versions of 1.2.1.0.39, 2.00 and later.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Hardware Structure

Hardware Structure

This topic describes the component layout and connectors of the CX910.

Figure 2-6 Components

1

CPU

2

Onboard GE switch module(Internal ports are reserved and cannot be used currently.)

3

10GE switch module

4

Heat sink

5

Midplane signal connector

6

Midplane power connector

Table 2-6 Components

No.

Component

Description

1

CPU

The CX910 uses two quad-core CPUs to manage the 10GE switch module respectively at a maximum of 1.5 GHz.

  • Provides one serial gigabit media independent port (SGMII) connecting to the baseboard management controller (BMC) to act as a management channel.
  • Provides the 10GE switch module with one PCIe x2 slot to configure and manage the switch chip.
  • Provides one serial port for debugging.

2

Onboard GE switch module

The onboard GE switch module provides four external GE ports on the panel for service management or chassis cascading. The internal ports are reserved and cannot be used currently.

3

10GE switch module

The 10GE switch module is the primary functional module on the CX910 and is used to forward service packets. It provides fifty-six 10GE ports and two 40GE ports as follows:

  • Forty internal 10GE ports: three 10GE ports for each half-width slot in positions Slot01 to Slot08 and two 10GE ports for each half-width slot in positions Slot09 to Slot16
  • Two internal 40GE ports for interconnecting two 10GE switch modules
  • 16 external 10GE ports for connecting to the SFP+ optical modules or direct attached cables (DACs) to provide service ports for switch modules and for connecting to external switch modules or other network devices

4

Heat sink

Cools CPUs. Each CPU is configured with one heat sink.

5

Midplane signal connector

Exchanges data between the CX910 and the midplane.

6

Midplane power connector

Supplies 12 V DC power for the CX910.

Translation
Download
Updated: 2018-09-20

Document ID: EDOC1000036339

Views: 13004

Downloads: 238

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next