No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX913 Switch Module V100R001C10 User Guide 15

This document describes the CX913 10GE switch module (CX913 for short) of the Tecal E9000 server in terms of its features, installation, removal, and configuration. This document applies to the CX913 whose 10GE switching planes use the software versions of 1.2.1.0.39, 2.00 and later.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Connection of an FC Port

Configuring the Connection of an FC Port

You can configure the connection relationship between an FC port of the FC pass through plane and a compute node based on the device requirements.

Scenarios

You can use one of the following methods to configure the connection relationship between an FC port of the FC pass through plane in the CX913 and a compute node:

Prerequisites

Conditions

  • You have powered on the CX913.
  • You have logged in to the MM910 WebUI.

Data

Data preparation is not required for this operation.

Procedure

Configure the connection relationship between an FC port and a compute node.

  1. On the HMM Web page, select Chassis Settings.

    The Chassis Settings page is displayed.

  2. In the navigation tree on the left of the Chassis Settings page, choose Basic Settings > FC port configuration,.

    Figure 4-3 FC Port Configuration

  3. Click Edit.

    You can edit the connection between an FC port on the specific switch module and a compute node.

  4. Click Save.

    The setting is complete.

Translation
Download
Updated: 2018-09-20

Document ID: EDOC1000036345

Views: 13420

Downloads: 183

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next