No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Hardware Installation and Maintenance Guide

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600

This section provides brief procedure for installing the AR series routers. This document describes preparations before AR series routers installation, installation methods and precautions, AR series routers maintenance, and common methods for troubleshooting typical hardware module faults.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting Ethernet Cables

Connecting Ethernet Cables

Context

  • Do not power on the router before you finish connecting cables.
  • Notice flags on interfaces when connecting cables. Incorrect cable connection may damage interface modules or the router.

Tools and Accessories

  • Diagonal pliers
  • Cable ties
  • Marker
  • Network cables (separately purchased)
  • Network cable labels

Procedure

  1. Select Ethernet cables of appropriate quantity and lengths according to the number of ports and measured cabling distances.
  2. Attach temporary labels to both ends of each Ethernet cable and write numbers on the labels to identify the Ethernet cables. For details, see Engineering Labels for Network Cables.
  3. Lead the Ethernet cables into the cabinet from the top cable inlet (for overhead cabling) or bottom cable inlet (for on-ground cabling), and route the cables from one side of the cabinet.
  4. Connect one end of an Ethernet cable to an Ethernet interface of the router and the other end to an Ethernet interface of the remote device.



  5. Arrange the Ethernet cables to make them parallel, and then bundle them with cable ties. Use diagonal pliers to cut off redundant cable ties.
  6. Remove the temporary labels from the Ethernet cables, and then attach formal labels 2 cm away from the connectors at both ends.

Follow-up Procedure

Check the following items after connecting Ethernet cables:

  • Labels are correctly filled and securely attached to cables, with texts facing the same direction.
  • Cables and connectors are complete, intact, and tightly connected.
Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000039117

Views: 67601

Downloads: 6512

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next