No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Hardware Installation and Maintenance Guide

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600

This section provides brief procedure for installing the AR series routers. This document describes preparations before AR series routers installation, installation methods and precautions, AR series routers maintenance, and common methods for troubleshooting typical hardware module faults.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting DC Power Cables

Connecting DC Power Cables

Context

To avoid electric shock, do not connect power cables while the power is on.

  • Do not power on a router before you finish connecting power cables and network cables.
  • Each router has its own power cables delivered as accessories. The power cables can only be used on the router in the same package and cannot be used on any other device.
NOTE:

The DC power cable parameters vary in different countries or regions. The figures in this section are for reference only and may differ from the cables delivered.

Tools and Accessories

  • ESD wrist strap
  • DC power cables
  • Cord end terminal
  • OT bare crimp terminal

Procedure

  1. Verify that the router is reliably grounded.
  2. Set the power switch to OFF.
  3. Wear an ESD wrist strap. Ensure that the ESD wrist strap is grounded and in a close contact with your wrist.
  4. Install cord end terminals or OT bare crimp terminals on the DC power cables.

    NOTE:

    The cord end terminals and OT bare crimp terminals are delivered in the installation accessory package. When using a DC power module in the router, select the terminals as required.

    • If the DC power supply system for the router requires cord end terminals, assemble the DC power cables by referring to Figure 6-11.
      Figure 6-11  Installing a cord end terminal

    • If the DC power supply system for the router requires OT bare crimp terminals, assemble the DC power cables by referring to Figure 6-12.
      Figure 6-12  Installing an OT bare crimp terminal

  5. Connect the DC power cables.
    1. Insert the one end of the DC power cables to the DC power terminals on the DC power module.
    2. Connect the other end of the power cables to output terminals of the external DC power supply system.



Follow-up Procedure

Perform the following operations after connecting the DC power cables:

  • Verify that DC power cables are securely connected to the power terminals.
  • If multiple routers are installed, attach labels to both ends of each power cable and write numbers on the labels to identify them.
Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000039117

Views: 67283

Downloads: 6507

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next