No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Hardware Installation and Maintenance Guide

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600

This section provides brief procedure for installing the AR series routers. This document describes preparations before AR series routers installation, installation methods and precautions, AR series routers maintenance, and common methods for troubleshooting typical hardware module faults.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Scenario 3: Mounting a Router on a Wall (AR1200 Series)

Scenario 3: Mounting a Router on a Wall (AR1200 Series)

Context

Before drilling holes on a wall, make sure that no power cable is routed in the wall. Otherwise, power cables in the wall may cause personal injury.

  • The interface side of a wall-mounted router must face down to protect interfaces from water.
  • Screws must be installed solid in the wall; otherwise, the wall-mounted router may fall down after cables are connected.
  • Ensure that there are no flammable or explosive materials near the router and no obstructions within 100 mm around the router.
  • Install the router at an appropriate height to ensure that the indicators can be observed easily.

Tools and Accessories

  • Measuring tape
  • Marker
  • Hammer drill
  • Claw hammer
  • Phillips screwdriver
  • Wall anchors and mounting screws (separately purchased)

Procedure

  1. Use a measuring tape to determine positions of two mounting holes, keep the two positions aligned, and mark the positions with a marker.



  2. Drill holes and install mounting screws.
    1. Choose an appropriate drill bit according to the diameter of the mounting screws. The diameter of the mounting screws cannot exceed 4 mm.
    2. Hammer the hollow wall anchors into the mounting holes.
    3. Use a Phillips screwdriver to screw the mounting screws into the wall anchors. Leave the screws protruding 2 mm from the wall.



  3. Align the mounting holes on the rear of the router with mounting screws and hang the router on the mounting screws.



Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000039117

Views: 67445

Downloads: 6508

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next