No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Hardware Installation and Maintenance Guide

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600

This section provides brief procedure for installing the AR series routers. This document describes preparations before AR series routers installation, installation methods and precautions, AR series routers maintenance, and common methods for troubleshooting typical hardware module faults.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Using Mounting Brackets (AR1200 Series)

Using Mounting Brackets (AR1200 Series)

Context

  • Leave at least 50 mm of clearance around the router for heat dissipation.
  • Seen from the front panel of the router, the airflow of the router is left to right.
  • If multiple routers are installed in a cabinet, it is recommended that at least 1 U of space (1 U = 44.45 mm) be kept between two routers. These routers must have the same airflow direction; otherwise, heat dissipation is affected by hot air circulation.

Make sure the following before the installation:

  • The cabinet is well fixed.
  • The router installation position in the cabinet is determined and arranged properly.
  • The router to be installed is available and located near the cabinet for convenient movement.

Tools and Accessories

  • Phillips screwdriver
  • Flat-head screwdriver
  • Floating nuts
  • Mounting brackets
  • M4 screws
  • M6 screws

Procedure

  1. Use a Phillips screwdriver to fix the mounting brackets to both sides of the router with M4 screws.

    NOTE:

    The mounting brackets can be installed on both sides close to the front panel or rear panel.



  2. Install two floating nuts on each front mounting rail. Leave a mounting hole between the two floating nuts on the same mounting rail.

    NOTE:
    • The length of three adjacent mounting holes may not be 1 U. Observe the scale ticks on the mounting rails when installing floating nuts.
    • You can use a flat-head screwdriver to install floating nuts.


  3. Move the router into the cabinet. Support the bottom of the router with one hand and tighten the M6 screws on the mounting brackets with the other hand. Tighten the lower screws first, and then the upper screws.



Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000039117

Views: 67488

Downloads: 6512

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next