No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Hardware Installation and Maintenance Guide

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600

This section provides brief procedure for installing the AR series routers. This document describes preparations before AR series routers installation, installation methods and precautions, AR series routers maintenance, and common methods for troubleshooting typical hardware module faults.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing a Power Module

Installing a Power Module

Context

Each router is configured with one power module by default. When you purchase another power module for a router, follow the instructions in this section to install the power module.

  • AC and DC power modules cannot be used together in the same router.
  • A power module can be hot swapped.
  • Vacant slots in the router must be covered with filler panels.

Tools and Accessories

  • ESD wrist strap
  • Phillips screwdriver

Procedure

  1. Wear an ESD wrist strap. Ensure that the ESD wrist strap is grounded and in a close contact with your wrist.
  2. Loosen the captive screw on the filler panel and remove the filler panel.
  3. Install a power module in the router.
    1. Rotate the ejector levers on the power module outward and slide the power module into the slot along the guide rails until the power module is completely attached to the router panel.
    2. Rotate the ejector levers inward to lock the power module in the slot.
    3. Use a Phillips screwdriver to tighten the captive screws on the power module.



Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000039117

Views: 63446

Downloads: 6423

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next