No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Hardware Installation and Maintenance Guide

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600

This section provides brief procedure for installing the AR series routers. This document describes preparations before AR series routers installation, installation methods and precautions, AR series routers maintenance, and common methods for troubleshooting typical hardware module faults.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking Installation Environment

Checking Installation Environment

Before installing a router, check whether the installation environment meets requirements. The router can work normally only when the environment meets requirements.

Table 2-1 lists requirements for the installation environment.
Table 2-1  Requirements for the installation environment

Check Item

Requirement

Heat dissipation

Leave at least 50 mm of clearance around the router for heat dissipation.

Cleanness

  • The router must be installed in a clean, dry, well ventilated site where temperature is controlled within a proper range.
  • The installation site must be free from leaking or dripping water, and heavy dew.

Temperature and humidity

  • Operating temperature: 0°C to 45°C
  • Operating relative humidity: 5% RH to 95% RH (noncondensing)
NOTE:

If the relative humidity exceeds 70%, use dehumidifiers or air conditioners with dehumidification features.

ESD

  • The router must be reliably grounded according to grounding requirements.
  • Wear an ESD wrist strap to prevent ESD damages to the router.
  • Ensure that the ESD wrist strap is grounded and in a close contact with your wrist.

Corrosive gases

There must be no acidic, alkaline, or other corrosive gases in the installation site.

Surge protection

  • Signal cables must be routed against walls indoors. Do not deploy signal cables overhead outdoors.
  • Keep signal cables away from power cables and surge protection devices.

Electromagnetic radiation

Comply with Electromagnetism Requirements for the Equipment Room.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000039117

Views: 68236

Downloads: 6519

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next