No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Hardware Installation and Maintenance Guide

AR100, AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600

This section provides brief procedure for installing the AR series routers. This document describes preparations before AR series routers installation, installation methods and precautions, AR series routers maintenance, and common methods for troubleshooting typical hardware module faults.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Powering On and Off the Router

Powering On and Off the Router

Context

Before you power on the router, check and ensure the following:

  • The power adapter is correctly connected.
  • The input voltage is in the range of 90 V AC to 264 V AC.

Procedure

  • Power on the router.

    Turn on the power switch of the power supply system, and then turn on the power switch on the router to start the router.

    After the router starts, check indicators on the front panel to check whether the router runs normally. Figure 5-12 describes the indicator states when the router is running normally.

    Figure 5-12  Normal indicator states on the router

    Indicator

    Description

    SYS

    Slow blinking green: The system is running properly.

  • Power off the router.

    Powering off the router will interrupt all the services on the router. Exercise caution when you perform this operation.

    Turn off the power switch on the router, and then turn off the power switch of the power supply system.

Follow-up Procedure

After the router starts, you can log in to its CLI to configure, manage, and maintain the router. For details, see the CLI-based Configuration.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000039117

Views: 77749

Downloads: 6767

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next