No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


RH5885 V3 Server V100R003 User Guide 32

This document describes the appearance, specifications, parameters, and structure of the RH5885 V3, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing the FlexIO Card

Installing the FlexIO Card

  1. Power off the server. For details, see Powering On and Off the RH5885 V3. Remove all power cables.
  2. Install the mainboard if it is not installed. For details, see Installing the Mainboard.
  3. Wear an ESD wrist strap or ESD gloves. For details, see Safety Instructions.
  4. Take the spare FlexIO card out of the ESD bag.
  5. (Optional) Install the baffle plate of the FlexIO card.


    If no baffle plate is delivered with the spare FlexIO card, remove the baffle plate from the FlexIO card for future use.

    Do not insert the baffle plate onto the FlexIO card horizontally. Otherwise, the pins of the network ports may be damaged.

    1. Hold the baffle plate with one hand and the two sides of the FlexIO card with the other hand. Tilting the FlexIO card a little bit to prevent collision of the screw holes of the baffle plate and the network port pins, insert the FlexIO card into the baffle plate in the direction shown by (1) in Figure 5-83. Ensure that the pins at the rear of the FlexIO card are beyond the screw holes.
    2. Close the baffle plate in the direction shown by (2) in Figure 5-83, and push the FlexIO card horizontally into the baffle plate as far as it will go.
    3. Use a Phillips screwdriver to tighten the screws to secure the baffle plate with the FlexIO card. See (3) in Figure 5-83. The positions of the screws vary depending on the FlexIO card model.
      Figure 5-83 Installing the baffle plate of the FlexIO card

  6. Place the FlexIO card horizontally and insert it into the chassis until it does not move. See step (1) in Figure 5-84.

    Figure 5-84 Installing the FlexIO card

  7. Screw the FlexIO card using a Phillips screwdriver. See step (2) in Figure 5-84.
Updated: 2019-10-21

Document ID: EDOC1000040297

Views: 125199

Downloads: 1614

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next