No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

RH5885 V3 Server V100R003 User Guide 32

This document describes the appearance, specifications, parameters, and structure of the RH5885 V3, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing the RH5885 V3 on L-shaped Guide Rails

Installing the RH5885 V3 on L-shaped Guide Rails

Ensure the following conditions are met before installing the RH5885 V3:

  • A rack is properly installed.
  • The installation environment check is complete based on Installation Overview.
NOTE:

L-shaped guide rails are delivered with Huawei racks. L-shaped guide rails are not delivered with the RH5885 V3.

Procedure

  1. Install floating nuts.

    1. Determine the position for installing a floating nut based on the installation plan.
      NOTE:

      The floating nuts and screws are used together to tighten the screws.

      The middle of two adjacent square holes with small spacing is the boundary of two Us. See Figure 3-2. The boundary between Us is used as the reference for calculating device installation space.

      Figure 3-2 Spacing of 1 U on a guide rail of a rack

    2. Fasten one end of a floating nut to the installation hole in a guide rail at the front of the rack. See Figure 3-3.
      Figure 3-3 Installing a floating nut

    3. Fasten the upper end of the floating nut to the mounting bar at the front of the rack by using the floating nut mounting bar.

  2. Install L-shaped guide rails.

    1. Place a guide rail horizontally in the planned position and keep the guide rail contact with the mounting bars in the rack. See Figure 3-4.
      Figure 3-4 Installing an L-shaped guide rail

    2. Tighten the screws.
    3. Install another guide rail on the opposite side by using the same method.

  3. Install the RH5885 V3.

    1. At least two persons lift the RH5885 V3 on two sides and move it to the rack.
    2. Place the RH5885 V3 on the guide rails and push it into the rack slowly, as shown in Figure 3-5.
      Figure 3-5 Installing the RH5885 V3

    3. When the two mounting ears on the RH5885 V3 contact the mounting bards of the rack, tighten the captive screws on the mounting ears to secure the RH5885 V3.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000040297

Views: 106750

Downloads: 1582

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next