No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


RH5885 V3 Server V100R003 User Guide 32

This document describes the appearance, specifications, parameters, and structure of the RH5885 V3, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing the FlexIO Card

Removing the FlexIO Card

  1. Power off the server. For details, see Powering On and Off the RH5885 V3. Remove all power cables.
  2. Wear an ESD wrist strap or ESD gloves. For details, see Safety Instructions.
  3. Unscrew the FlexIO card using a Phillips screwdriver. See step (1) in Figure 5-81.

    Figure 5-81 Removing the FlexIO card

  4. Remove the FlexIO card from the RH5885 V3. See step (2) in Figure 5-81.
  5. (Optional) Remove the baffle plate from the FlexIO card.


    If no baffle plate is delivered with the spare FlexIO card, remove the baffle plate from the FlexIO card for future use.

    When removing the baffle plate from the FlexIO card, do not pull out the FlexIO card horizontally. Otherwise, the pins of the network ports may be damaged.

    1. Use a Phillips screwdriver to loosen the screws that secure the baffle plate with the FlexIO card. See (1) in Figure 5-82. The positions of the screws vary depending on the FlexIO card model.
    2. Keeping the FlexIO card horizontally level, hold the baffle plate with one hand and the two sides of the FlexIO card with the other hand. Pull apart the baffle plate in the direction shown by (2) in Figure 5-82. Check whether the screw holes on the other side of the plate are completely separated from the network port pins.
    3. Ensure that the screw holes and the network port pins do not contact, and remove the FlexIO card horizontally. See (3) in Figure 5-82.
      Figure 5-82 Removing the baffle plate from the FlexIO card

  6. Place the removed FlexIO card in an ESD bag.
Updated: 2019-10-21

Document ID: EDOC1000040297

Views: 110728

Downloads: 1598

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next