No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

RH5885 V3 Server V100R003 User Guide 30

This document describes the appearance, specifications, parameters, and structure of the RH5885 V3, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing an AC PSU

Removing an AC PSU

When PSUs are fully configured, you can remove a PSU without powering off the RH5885 V3 if the other PSUs are operating properly.

Observe the PSU indicators to check the PSU operating status.

Procedure

  1. Wear an ESD wrist strap or ESD gloves. For details, see Safety Instructions.
    • The PSUs support double-pole/neutral fusing.
    • The recommended current specifications for the external power circuit breaker connected to the RH5885 V3 are as follows: ≥ 36 A AC

  2. Remove a power cable from a PSU.

    • If the PSU has a velcro strap, undo the velcro strap. See step (1) in Figure 5-18. Then remove the power cable. See step (2) in Figure 5-18.
    Figure 5-18 Removing a power cable (secured with the PSU using a velcro strap)

    • If the PSU has a plastic clip, perform the following steps to remove the power cable:
      1. Open the lock of the plastic clip. See a of step (1) in Figure 5-19. Slide the plastic clip away from the PSU socket. See b of step (1) in Figure 5-19.
        Figure 5-19 Removing a power cable (secured with the PSU using a plastic clip)

      2. Open the plastic clip. See step (2) in Figure 5-19.
      3. Remove the power cable from the plastic clip. See step (3) in Figure 5-19.

  3. Hold down the release button, and hold the handle to pull out part of the PSU. See step (1) in Figure 5-20.

    Figure 5-20 Removing a PSU

  4. Release the release button, and remove the PSU from the slot. See step (2) in Figure 5-20.
  5. Place the removed PSU into an ESD bag.
Translation
Download
Updated: 2018-10-24

Document ID: EDOC1000040297

Views: 84217

Downloads: 1548

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next