No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

RH5885 V3 Server V100R003 User Guide 32

This document describes the appearance, specifications, parameters, and structure of the RH5885 V3, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting Cables to a Mouse, Keyboard, and VGA Port

Connecting Cables to a Mouse, Keyboard, and VGA Port

After powering on the server, a connected keyboard and mouse is required to set the basic input/output system (BIOS) and RAID, and log in to the operating system (OS).

The front and rear panels of the server provide DB15 video graphics array (VGA) ports but have no standard PS2 port for a keyboard or mouse. You can connect the keyboard and mouse to the USB ports on the front or rear panel based on actual installation conditions. The following describe two connection methods:

  • Connect the keyboard and mouse to the USB ports.
  • Connect the keyboard and mouse by using a USB-to-PS2 cable.

Procedure

  1. Connect the USB connector on the PS2 cable to the USB port on the front or rear panel of the server.
  2. Connect the connectors on the other end of the PS2 cable to the keyboard and mouse.
  3. Connect the DB15 connector on the VGA cable to the VGA port on the front or rear panel of the server, and tighten the two screws on the connector to secure the cable.
  4. Connect the other end of the VGA cable to the VGA port on the monitor, and tighten the two screws on the connector to secure the cable.

    Figure 3-21 Connecting a PS2 cable and VGA cable

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000040297

Views: 107697

Downloads: 1584

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next