No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


RH5885 V3 Server V100R003 User Guide 30

This document describes the appearance, specifications, parameters, and structure of the RH5885 V3, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing the NIC

Installing the NIC

  1. Power off the server. For details, see Powering On and Off the RH5885 V3. Remove all power cables.
  2. Install the mainboard if it is not installed. For details, see Installing the Mainboard.
  3. Wear an ESD wrist strap or ESD gloves. For details, see Safety Instructions.
  4. Take the spare NIC out of the ESD bag.
  5. Install the NIC in the bracket. See (1) in Figure 5-83.

    Figure 5-83 Installing the NIC in the bracket

  6. Tighten the screws of the NIC using a Phillips screwdriver. See (2) in Figure 5-83.
  7. Place the NIC horizontally and insert it into the chassis until it does not move. See step (1) in Figure 5-84.

    Figure 5-84 Installing the NIC

  8. Screw the NIC using a Phillips screwdriver. See step (2) in Figure 5-84.
Updated: 2018-10-24

Document ID: EDOC1000040297

Views: 82906

Downloads: 1543

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next