No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

RH5885 V3 Server V100R003 User Guide 32

This document describes the appearance, specifications, parameters, and structure of the RH5885 V3, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing the Server and Holding Rails

Removing the Server and Holding Rails

  1. Wear an ESD wrist strap or ESD gloves. For details, see Safety Instructions.
  2. Power off the server. For details, see Powering On and Off the RH5885 V3.
  3. Disconnect all power cables and signal cables from the server.
  4. Remove the server.

    1. Loosen the captive screws on the server panel using a screwdriver. See (1) in Figure 4-5.
      Figure 4-5 Removing the server from the holding rails

    2. Pull out the server along the guide rails away from the cabinet as far as the server will go. See (2) in Figure 4-5.
    3. Press inner rail lock, and pull the server out. See (1) and (2) in Figure 4-6.
      Figure 4-6 Removing a server from holding rails

    4. Place the removed server onto an ESD platform.
    5. Lift the inner rail lock, and remove the inner rail. See Figure 4-7.
      Figure 4-7 Removing an inner rail

  5. Remove the front end of the holding rail.

    1. Hold down the plate on the front end of the holding rail and pull out the hook. See (1) and (2) in Figure 4-8.
      Figure 4-8 Removing a holding rail 1

    2. Push the holding rail out of the square holes. See (3) in Figure 4-9.
      Figure 4-9 Removing a holding rail 2
    3. Remove the front end of the holding rail. See (4) in Figure 4-9.
    4. Push the plate into the holding rail. See (5) in Figure 4-10.
      Figure 4-10 Removing a holding rail 3

  6. Remove the rear end of the holding rail.

    Lift the positioning pin and remove the holding rail from the square holes. See (6) and (7) in Figure 4-11.

    Figure 4-11 Removing a holding rail 4

  7. Remove the other guide rail on the opposite side in the same way.
Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000040297

Views: 105825

Downloads: 1582

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next