No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

RH5885 V3 Server V100R003 User Guide 30

This document describes the appearance, specifications, parameters, and structure of the RH5885 V3, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing the Supercapacitor

Removing the Supercapacitor

  1. Power off the server. For details, see Powering On and Off the RH5885 V3. Remove all power cables.
  2. Remove the chassis cover of the RH5885 V3. For details, see Removing the Chassis Cover.
  3. Remove the riser card tray above the RAID controller card. For details, see Removing the Riser Card.
  4. Remove the air duct of the RH5885 V3. For details, see Removing the Air Duct.
  5. Wear an ESD wrist strap or ESD gloves. For details, see Safety Instructions.
  6. Hold down the plastic latches on the supercapacitor tray. See step (1) in Figure 5-54.

    Figure 5-54 Removing the supercapacitor tray

  7. Pull the supercapacitor tray in the arrow direction to remove it. See step (2) in Figure 5-54.
  8. Vertically lift the trans flash module (TFM) out of the RAID controller card. See step (1) in Figure 5-55.

    Figure 5-55 Removing the supercapacitor

  9. Open the plastic latches that secure the supercapacitor. See step (2) in Figure 5-55.
  10. Exert even force to remove the supercapacitor from the tray. See step (3) in Figure 5-55.
  11. Place the removed supercapacitor in an ESD bag.
Translation
Download
Updated: 2018-10-24

Document ID: EDOC1000040297

Views: 82256

Downloads: 1541

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next