No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

RH5885 V3 Server V100R003 User Guide 30

This document describes the appearance, specifications, parameters, and structure of the RH5885 V3, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing the RH5885 V3 on Adjustable Guide Rails

Installing the RH5885 V3 on Adjustable Guide Rails

Ensure the following conditions are met before installing the RH5885 V3:

  • A rack is properly installed.
  • The installation environment checking is complete based on Installation Overview.

Procedure

  1. Install adjustable guide rails.

    1. Use a screwdriver to fasten one dowel pin on front and two dowel pins on the rear of the guide rail. ‎Figure 3-6 shows the positions of dowel pins.
      NOTE:

      Three types of dowel pins are shipped with the guide rails, and their diameters are 6.8 mm (0.27 in.), 8.7 mm (0.34 in.), and 9.2 mm (0.36 in.). You choose a dowel pin based on the size of the mounting bar. Ensure that the diameter of a hole in the mounting bar is slightly greater than that of a dowel pin.

      Figure 3-6 Installing a dowel pin

    2. Place a guide rail horizontally in the planned position and stretch the guide rail and align the holes on the guide rail with the holes on the inner guide rail of the rack. See step (1) in Figure 3-7.
      NOTE:

      Guide rails are divided into left and right guide rails (labeled with L and R). A pair of guide rails should be installed together and cannot be installed reversely.

    3. Use a screwdriver to tighten two screws on front and two screws on the rear of the guide rail. See step (2) in ‎‎Figure 3-7. The figure shows the positions of screws.
      Figure 3-7 Installing an adjustable guide rail

    4. Install another guide rail on the opposite side by using the same method.

  2. Install the RH5885 V3.

    1. At least two persons lift the RH5885 V3 on two sides and move it to the rack.
    2. Place the RH5885 V3 on the guide rails and push it into the rack slowly, as shown in Figure 3-8.
      Figure 3-8 Installing the RH5885 V3

    3. When the two mounting ears on the RH5885 V3 contact the mounting bards of the rack, tighten the captive screws on the mounting ears to secure the RH5885 V3.

Translation
Download
Updated: 2018-10-24

Document ID: EDOC1000040297

Views: 72884

Downloads: 1525

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next