No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

RH5885 V3 Server V100R003 User Guide 30

This document describes the appearance, specifications, parameters, and structure of the RH5885 V3, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting a Serial Cable

Connecting a Serial Cable

TheRH5885 V3 server provides one standard DB9 serial port on the rear, which works as the system serial port by default. You can set it to the iMana 200 or iBMC serial port on the iMana 200 or iBMC CLI.

The serial port can be used in the following scenarios:

  • Used as the system serial port to monitor the status of the operating system (OS).
  • Used as the iMana 200 or iBMC serial port for debugging and fault locating.

Procedure

  1. Do not exert excessive force; otherwise, the pins in the serial port may be damaged.

    Align the connector on the serial cable with the serial port, and insert the connector into the serial port, as shown in Figure 3-24.

  2. Tighten the screws on the connector to secure the serial cable.

    Figure 3-24 Connecting a serial cable

Translation
Download
Updated: 2018-10-24

Document ID: EDOC1000040297

Views: 74062

Downloads: 1527

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next