No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei Server Maintenance Manual 09

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to the MM510 CLI

Logging In to the MM510 CLI

MM510 is the management module of the FusionServer G5500.

Prerequisites

  • If you log in to the CLI over SSH, a maximum of five concurrent users are supported.
  • If you log in to the CLI over the network port, the network ports of the terminal are connected to the server by using a network cable, and the IP addresses of the two network ports are in the same network segment.
  • If you log in to the CLI over the serial port, the serial ports of the terminal are connected to the server by using a serial cable.

Login Method

  • Login over SSH
  • Login over the local serial port
    NOTE:
    • The HMM provides one default user Administrator, and the default password is on the product nameplate.
    • The system locks a user account if the user enters incorrect passwords for five consecutive times. The user is automatically unlocked 5 minutes later, or an administrator can unlock the user on the CLI.
    • For security purposes, change the initial password after the first login and change your password periodically.

Logging In over SSH

The Secure Shell (SSH) protocol provides secure remote login and other secure network services over an insecure network.

The methods for logging in to the CMC CLI over SSH varies according to the client operating system:

  • If the client uses Linux:
    1. Connect the client to the management network port on the server.
    2. Run the ssh ipaddress command on the terminal tool (for example, shell) to log in to the CLI. (In the command, ipaddress indicates the IP address of the management network port.)
NOTE:

At the initial startup of the HMM, wait for about 3 minutes before you log in to the CLI.

  • If the client uses Windows:
    1. Download and install the SSH client communication tool.
    2. Connect the client to the management network port on the server.
    3. Enter the IP address, user name, and password of the management network port on the client communication tool.

Logging In over a Serial Port

  1. Connect the serial cable.
  2. Log in to the CLI by using the HyperTerminal and set the following parameters:
    • Bits per second: 115200
    • Data bits: 8
    • Parity: None
    • Stop bits: 1
    • Flow control: None

    Figure 3-35 lists the parameters to be specified.

    Figure 3-35 HyperTerminal properties
  3. Enter the user name and password after the connection is established.
Translation
Download
Updated: 2019-02-25

Document ID: EDOC1000041338

Views: 83164

Downloads: 3889

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next