No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei Server Maintenance Manual 09

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to a Server Over a Network Port by Using PuTTY

Logging In to a Server Over a Network Port by Using PuTTY

Scenarios

Use PuTTY to remotely log in to the server over a local area network (LAN) and to configure and maintain the server.

NOTE:

The server in this section can be a management module, compute node, or switching plane.

Prerequisites

  • A PC is connected to the management network port of MM910 by using a network cable.
  • You have obtained the IP address of the server to be connected.
  • You have obtained the user name and password for logging in to the server to be connected.
  • You have installed PuTTY.exe.

Procedure

  1. Set an IP address and a subnet mask or add route information for the PC so that the PC can properly communicate with the server.

    You can run the Ping Server IP address command on the PC CLI to check the communication between the PC and the server.

  2. Double-click PuTTY.exe.

    The PuTTY Configuration window is displayed, as shown in Figure 3-38.

    Figure 3-38 PuTTY Configuration window

  3. Set the login parameters.

    • Host Name (or IP address): Enter the IP address of the server to be logged in to, for example, 191.100.34.32.
    • Port: Retain the default value 22.
    • Connection type: Retain the default value SSH.
    • Close window on exit: Retain the default value Only on clean exit.
    NOTE:

    Configure Host Name and Saved Sessions, and click Save. You can double-click the saved record under Saved Sessions to log in to the server the next time.

  4. (Optional) After logging in to the Ethernet plane by using PuTTY, if you fail to delete characters on the CLI by using the Backspace key, choose Terminal > Keyboard, and select Control-H under The Backspace key, as shown in Figure 3-39.

    Figure 3-39 PuTTY Configuration

  5. Click Open.

    The PuTTY window is displayed.

    NOTE:

    If this is your first login to the server, the PuTTY Security Alert dialog box is displayed. Click Yes to proceed.

  6. Enter a user name and password.

    NOTE:

    If an incorrect user name or password is entered, you must set up a new PuTTY session.

    If the login is successful, the server host name is displayed on the left of the prompt.

Translation
Download
Updated: 2019-02-25

Document ID: EDOC1000041338

Views: 70144

Downloads: 3773

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next