No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 12

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Applications

Applications

This section describes the applicable scenario of MLD.

Typical MLD Application

MLD runs between member hosts and directly connected multicast routers to manage and maintain multicast group memberships. To forward multicast data from multicast sources to receivers, multicast routers must run Protocol Independent Multicast (PIM) IPv6 to set up forwarding paths. Figure 8-41 illustrates a typical MLD network topology.

Figure 8-41 Typical MLD network topology

The following solutions can be used in MLD applications.

Solution

Member Hosts

Interfaces Connected to Member Hosts

All Routers on the Network

Hosts dynamically join multicast groups through ASM.

Enable MLDv1 or MLDv2.

Enable MLDv1 or MLDv2.

Enable Bidir-PIM (IPv6) or PIM-SM (IPv6).

Hosts dynamically join multicast groups through SSM.

Enable MLDv2.

Enable MLDv2.

Enable PIM-SM (IPv6).

Hosts dynamically join multicast groups through SSM mapping.

Enable MLDv1.

Enable MLDv2, enable MLD SSM mapping, and configure source-group mapping.

Enable PIM-SM (IPv6).

Translation
Download
Updated: 2019-08-09

Document ID: EDOC1000041694

Views: 58896

Downloads: 3621

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next