No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 12

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Principles

Principles

This section describes only the differences between RIP and RIPng. For details about the RIP implementation principles, see Principles.

RIPng

In addition to IPv4 networks, RIP is also applicable to IPv6 networks to provide accurate route information for IPv6 packets. IETF has defined RIP next generation (RIPng) based on RIP for IPv6 networks. RIPng is an important protocol for IPv6 networks.

Comparison Between RIPng and RIP

RIPng made the following modifications to RIP:

  • RIPng uses UDP port 521 to send and receive routing information.
  • RIPng uses the destination addresses with 128-bit prefixes (mask length).
  • RIPng uses 128-bit IPv6 addresses as next hop addresses.
  • RIPng uses the local link address FE80::/10 as the source address to send RIPng Update packets.
  • RIPng periodically sends routing information in multicast mode and uses FF02::9 as multicast address.
  • A RIPng packet consists of a header and multiple route table entries (RTEs). In a RIPng packet, the maximum number of RTEs depends on the MTU on the interface.
Translation
Download
Updated: 2019-08-09

Document ID: EDOC1000041694

Views: 58610

Downloads: 3621

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next