No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 12

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling/Disabling Configuration File Synchronization

Enabling/Disabling Configuration File Synchronization

This topic describes how to enable and disable configuration file synchronization between a switch module and the MM910.

Prerequisites

Make sure the following prerequisites are met before configuring the startup configuration file:
  • The switch module is running properly, and users can locally and remotely log in to the switch module.
  • The MM910 is properly installed and is running properly.

Context

Configure the configuration file synchronization to the MM910 on the command-line interface (CLI) based on site requirements as follows:
  • Enable configuration file synchronization.
  • Disable configuration file synchronization.
  • Disable configuration file synchronization before this restart.
    NOTE:
    If you disable configuration file synchronization before this restart, configuration file synchronization to the MM910 is disabled before this restart and is enabled automatically after the restart, and the switch module downloads the configuration file from the MM910 after the restart.

Procedure

  1. Enable configuration file synchronization.

    <HUAWEI> undo config-sync disable

  2. Disable configuration file synchronization.

    <HUAWEI> config-sync disable

  3. Disable configuration file synchronization before this restart.

    <HUAWEI> config-sync disable before-reboot

Translation
Download
Updated: 2019-08-09

Document ID: EDOC1000041694

Views: 59746

Downloads: 3623

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next