No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 12

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Notes

Configuration Notes

This section provides the notes about configuring VRRP.

When configuring VRRP on the switch modules, pay attention to the following points:
  • VRRP groups on one interface must use different virtual IP addresses. The virtual IP address of a VRRP group must be on the same network segment as the IP address of the interface where the VRRP group is configured.
  • The devices in a VRRP group must be configured with the same VRID.
  • Different interfaces can be bound to the same VRRP group.
  • If both VRRP and static ARP are configured on a VLANIF interface on a device, an IP address mapped to a static ARP entry cannot be used as a virtual IP address. If a VRRP virtual IP address is an IP address mapped to a static ARP entry on the device, the device generates incorrect host routes, affecting traffic forwarding.
  • In mVRRP, if a device has a virtual IP address, the device does not support load balancing.
  • The direct route generated by the virtual IP address in a VRRP group can be imported by OSPF, IS-IS, and RIP. By default, this type of route can be advertised by OSPF, IS-IS, and RIP to the neighboring devices. In practice, a large number of routes may be generated by the virtual IP addresses in a VRRP group; if all of the routes are imported and advertised to the neighboring devices by OSPF, IS-IS, and RIP, there is a heavy load on some devices on the networks and the network performance is affected. In this situation, you can use the vrrp virtual-ip route-advertise disable command to disable OSPF, IS-IS, and RIP from advertising the routes generated by the virtual IP addresses in the VRRP group.
Translation
Download
Updated: 2019-08-09

Document ID: EDOC1000041694

Views: 57909

Downloads: 3621

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next