No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 13

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring UDP Helper

Configuring UDP Helper

The UDP helper function relays the UDP broadcast packets destined for specified ports.

Pre-configuration Tasks

Before configuring UDP helper, complete the following task:

  • Configuring a reachable route from the switch modules to the destination server

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    ip udp-helper enable

    UDP helper is enabled.

    By default, UDP Helper is disabled.

    • After UDP Helper is enabled, the device can relay broadcast packets carrying one of the following six default UDP port numbers: 37 (Time Server), 49 (TACACS), 53 (DNS), 69 (TFTP), 137 (NetBIOS-NS), and 138 (NetBIOS-DS).
    • UDP Helper cannot relay DHCP packets. Specifically, the UDP port number cannot be set to 67 or 68. DHCP relay must be enabled to relay DHCP packets.
    • If the interface number to be configured is not one of the default UDP port numbers, go to Step 3 to configure the UDP port number.
    • If the device does not need to relay broadcast packets carrying one of the following UDP interface numbers: 37 (Time), 49 (TACACS), 53 (DNS), 69 (TFTP), 137 (NetBIOS-NS), and 138 (NetBIOS-DS), go to Step 4.

  3. (Optional) Run:

    ip udp-helper port port-number [ description description ]

    The UDP destination port to which UDP broadcast packets are relayed is specified.

  4. (Optional) Run:

    ip udp-helper port disable { port-number | dns | netbios-ds | netbios-ns | tacacs | tftp | time }

    The UDP destination port to which UDP broadcast packets are relayed is deleted.

  5. Run:

    interface interface-type interface-number

    The interface view is displayed.

    The interface must be a VLANIF interface.

  6. Run:

    ip udp-helper server ip-address

    The destination server for UDP helper is specified.

  7. Run:

    commit 

    The configuration is committed.

Checking the Configuration

  • Run the display ip udp-helper port command to check the UDP port numbers of the packets that need to be relayed.
Translation
Download
Updated: 2019-12-13

Document ID: EDOC1000041694

Views: 60616

Downloads: 3623

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next