No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 12

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Task Summary

Configuration Task Summary

This section describes IGMP configuration tasks.

Table 8-20 lists IGMP configuration tasks.

Table 8-20 IGMP configuration tasks

Scenario

Description

Task

Configure basic IGMP functions

To configure receiver hosts to join a multicast network and receive multicast data, you must configure basic IGMP functions on the switch modules interfaces connected to the receiver hosts.

Configuring Basic IGMP Functions

Optimize IGMP performance

After basic IGMP functions are configured on the multicast switch modules, the multicast switch modules can exchange IGMP messages with receiver hosts by default. You can optimize IGMP performance on the multicast switch modules according to requirements of network security and performance optimization.

Optimizing IGMP Performance

Configure IGMP SSM mapping

The Source-Specific Multicast (SSM) model allows IGMPv3 hosts to specify the multicast sources from which they want to receive data. In some cases, receiver hosts can run only IGMPv1 or IGMPv2. To allow these hosts to use SSM, you can configure IGMP SSM mapping on the multicast switch modules to provide the SSM service for IGMPv1 or IGMPv2 receiver hosts.

Configuring IGMP SSM Mapping
Translation
Download
Updated: 2019-08-09

Document ID: EDOC1000041694

Views: 59822

Downloads: 3623

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next