No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 13

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Common Configuration Errors

Common Configuration Errors

Traffic Is Unevenly Load Balanced Between Eth-Trunk Member Interfaces Due to the Incorrect Load Balancing Mode

Fault Description

Traffic is unevenly load balanced between Eth-Trunk member interfaces due to the incorrect load balancing mode.

Procedure

  1. Run the display eth-trunk command to check whether the load balancing mode of the Eth-Trunk meets networking requirements. For example, source or destination IP address-based load balancing is not recommended in Layer 2 networking.

  2. Run the load-balance command to set the proper load balancing mode.

    You can set the load balancing mode based on traffic models. When a parameter of traffic changes frequently, you can set the load balancing mode based on this parameter to ensure that the traffic is load balanced evenly. For example, if IP addresses in packets change frequently, use the load balancing mode based on dst-ip, src-ip, or src-dst-ip so that traffic can be properly load balanced among physical links. If MAC addresses in packets change frequently and IP addresses are fixed, use the load balancing mode based on dst-mac, src-mac, or src-dst-mac so that traffic can be properly load balanced among physical links.

Translation
Download
Updated: 2019-12-13

Document ID: EDOC1000041694

Views: 61606

Downloads: 3623

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next