No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 12

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Tasks Summary

Configuration Tasks Summary

This section describes MLD configuration tasks.

Table 8-27 describes MLD configuration tasks.

Table 8-27 MLD configuration tasks

Scenario

Description

Task

Configure basic MLD functions

To enable receiver hosts to join an IPv6 multicast network and receive multicast data, you must configure basic MLD functions on the switch modules interface connected to the receiver hosts.

Configuring Basic MLD Functions

Optimize MLD Performance

After basic MLD functions are configured on the multicast switch modules, the switch modules can exchange MLD messages with member hosts to maintain group membership with the default configurations. You can optimize MLD performance on the switch modules according to requirements of network security and performance optimization.

Optimizing MLD Performance

Configure MLD SSM mapping

The SSM model allows MLDv2 hosts to specify the multicast sources from which they want to receive data. In some cases, receiver hosts can run only MLDv1. To allow these hosts to use SSM, configure MLD SSM mapping on the switch modules to provide the SSM service for MLDv1 receiver hosts.

Configuring MLD SSM Mapping
Translation
Download
Updated: 2019-08-09

Document ID: EDOC1000041694

Views: 57228

Downloads: 3617

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next