No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CX11x, CX31x, CX710 (Earlier Than V6.03), and CX91x Series Switch Modules V100R001C10 Configuration Guide 13

The documents describe the configuration of various services supported by the CX11x&CX31x&CX91x series switch modules The description covers configuration examples and function configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Common Configuration Errors

Common Configuration Errors

This section describes the common configuration errors and troubleshooting methods.

A Multicast Static Route Fails to Take Effect

Fault Description

A device does not run any dynamic routing protocols, and a multicast static route is configured on the device. Multicast data cannot be forwarded to user hosts through this multicast static route although the physical status and link-layer protocol status of the interface are both Up.

Procedure

  1. Check whether the multicast static route is configured correctly and has been added to the multicast routing table.

    Run the display multicast routing-table static command to check whether the multicast static route is configured correctly.

    If the multicast static route is not correctly configured or it does not match the network topology because the topology has changed, the multicast routing table does not contain the routing entry and configuration of the multicast static route. In this case, run the ip rpf-route-static command to configure a multicast static route that matches the current network topology.

  2. Check whether the multicast static route has been added to the routing table of the specified routing protocol.

    If a routing protocol is specified for the multicast static route, run the display ip routing-table command to check whether this route has been added to the routing table of the protocol. If not, configure a matching unicast route for the routing protocol.

  3. Check whether the multicast static route matches the specified routing policy.

    If a routing protocol is specified for the multicast static route, run the display route-policy command to check whether the source address of the multicast static route matches the matching rule of the routing policy. If not, run the route-policy command to change the matching rule of the routing policy. Ensure that the multicast static route matches the routing policy and can be added to the routing table.

Translation
Download
Updated: 2019-12-13

Document ID: EDOC1000041694

Views: 60618

Downloads: 3623

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next